Video
Cette page contient la video: From ETS File to KNX Project View | KNX to C4 AI Assistant.
Chapitres de la video
- 0:00 — Create a project
- 0:11 — Upload the ETS project
- 0:58 — Topology and KNX devices
- 1:27 — Communication Objects and Group Addresses
- 1:59 — Map view and locations
- 2:49 — Project information summary
Transcription anglaise complete
Sous-titres anglais automatiques de la video YouTube publiee, avec une legere normalisation des noms de produit.
[0:00] To create a new project is very simple. We tap here. We select a name for the project. And basically here it ask us to upload the ETS file. So we are going to add this one. And now the system is going to grab all the information about the connect file when it's ready. basically it bring us to the inside the project information here. We have something important. We have a KNX parts and a Control4 parts. The KNX part is block is enabled but the Control4 parts is blocked at this point. What we are going to do is navigate a little bit from here. We have basically three menus. One is topology
[1:00] where you can basically see very easily the top topology of the KNX devices. So we have all the devices also give you some information about them. You can see the areas, the lines and so on. here for example you can u expand and go to specific devices. For example, this is an actuator. Here we can see only the communication objects that they have assigned group address. so we have information about the type of communication objects the function and the group address been b bound to them. Then we have location structure. here it represent basically the same ETS project structure about buildings floor rooms building parts cabinets and so on. And also we have developed
[2:00] this nice view that what we call the map view where you can easily navigate across the different locations of the projects and devices inside the different locations. And the same if you click in this device you go to the device communication objects with the group addresses. Then we have the group address menu that for now is quite limit but you can select different group address. You have information about the the points the name and the description and the amount of devices that that are using this group address. maybe if I found someone that is repeats. Not not this case here. For example, this this group address is being used in two different devices. We have the device information. This at this point, this is only descriptive. I mean the idea is
[3:00] you have what we feel that is necessary to understand the KNX project. So, you don't need to go back and forth to the ETS to understand this.
